2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1713

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1713

* SLC1 target current is not changed.

P0966

* The ignition voltage is between 10.2-15.5 V.

* The engine speed is greater than 400 RPM for 2 s.

* The transmission is not in emergency mode.

* Driving in D range.

* TCM communication is normal.

* DTC P0967 is not set.

P0967

* The ignition voltage is between 10.2-15.5 V.

* The engine speed is greater than 400 RPM for 2 s.

* The transmission is not in emergency mode.

* Driving in D range.

* TCM communication is normal.

* DTC P0966 is not set.

Conditions for Setting the DTC

P0778

Deviation between commanded current and feedback current.

P0965

The TCM detects the error current more than 80 mA for 2.75 ms.

P0966

The TCM detects at least 5 times less than 23 mA current consumption of the SLC1 control circuit for 100 ms.

P0967

The TCM detects at least 5 times more than 1.333 A current consumption of the SLC1 control circuit for 100 ms.

Action Taken When the DTC Sets

P0778, P0965

* DTC P0965 is a Type B DTC.

* The TCM turns OFF all solenoids.

* The TCM allows the vehicle after a stop to operate only in the second gear and "R" range.

P0966, P0967

* DTCs P0966 and P0967 are Type B DTCs.

* No self learning function.

* The TCM turns OFF all solenoids.

* The TCM allows the vehicle after a stop to operate only in the second gear and "R" range.

Conditions for Clearing the DTC

P0778, P0965

* DTC P0967 is a Type B DTC.

* The TCM detects the error current less than 50 mA for 2.75 ms.

P0966, P0967

* DTCs P0966 and P0967 are Type B DTCs.

* The current consumption of the SLC1 control circuit is 0.1-1.1 A for 500 ms.

Diagnostic Aids

When attempting to set solenoid electrical DTCs, ensure the TCM is warmed up and the transmission is operated in 2nd gear long enough to ensure

a 3掳C (5掳F) increase in TCM substrate temperature. This will place the TCM under the optimal conditions to test solenoid electrical DTCs.

Reference Information

Schematic Reference

Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams/Electrical

Diagrams)

Connector End View Reference