Wednesday, January 1, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1413

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1413



is 100%.



瀚慖f not the specified value, test the control circuit for a short to voltage. If the circuit tests normal, replace the K33 HVAC Control Module.



6. If all circuits test normal, test or replace the Q46 Air Conditioning Compressor Valve.



Component Testing



Static Test



1. Ignition OFF, disconnect the harness connector at the Q46 Air Conditioning Compressor Valve.



2. Test for 7-15 ohm between B+ circuit terminal 2 and control circuit terminal 1.



瀚慖f not within the specified range, replace the Q46 Air Conditioning Compressor Valve.



3. Test for infinite resistance between each terminal and the Q46 Air Conditioning Compressor Valve housing/case.



瀚慖f not the specified value, replace the Q46 Air Conditioning Compressor Valve.



Repair Instructions



Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.



* HVAC Component Replacement Reference (See: Heating and Air Conditioning/Service and Repair/Removal and Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for HVAC control module replacement, setup, and



programming



P0532



DTC P0532 or P0533



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptors



DTC P0532 00



- Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit Low Voltage



DTC P0533 00



- Air Conditioning (A/C) Refrigerant Pressure Sensor Circuit High Voltage



Circuit/System Description



The engine control module (ECM) monitors the high side refrigerant pressure through the A/C refrigerant pressure sensor. The ECM supplies a 5 V



reference and a low reference to the sensor. Changes in the A/C refrigerant pressure cause the sensor signal to the ECM to vary. When the pressure



is high, the signal voltage is high. When the pressure is low, the signal voltage is low. When pressure is high, the ECM commands the cooling fans



on. When pressure is too high or too low, the ECM will not allow the activation of the A/C compressor.



Conditions for Running the DTC



Engine is running.



Conditions for Setting the DTC



P0532 00



The ECM detects a short to ground or open at the A/C pressure sensor signal circuit.



P0533 00



The ECM detects a short to voltage at the A/C pressure sensor signal circuit.



Action Taken When the DTC Sets

No comments:

Post a Comment