Friday, January 3, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1427

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1427



Engine Control Module



The engine control module detects a system voltage above 16 V for less than 1 second.



Fuel Pump Control Module or Transmission Control Module



The module detects the system voltage is greater than 18 V.



Action Taken When the DTC Sets



DTC P0563 is a C type DTC.



Conditions for Clearing the DTC



DTC P0563 is a C type DTC.



Diagnostic Aids



* A possible cause of this DTC could be overcharging with a battery charger or jump starting.



* A high voltage value in multiple modules indicates a concern in the charging system.



Reference Information



Schematic Reference



* Engine Controls Schematics (LAU) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)Engine Controls



Schematics (LF1) (See: Diagrams/Electrical Diagrams/Powertrain Management/System Diagram)



* Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams) for the



MH2 and MH4 transmissions



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Charging System Description and Operation (See: Starting and Charging/Charging System/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Engine running, accessories OFF, measure and record the battery voltage at the C1 battery terminals. The voltage should be between 12.6 and



15.0 V.



瀚慖f not within the specified range, refer to Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests



and General Diagnostics/Charging System Test).



2. Engine running, observe the scan tool of the appropriate control module Ignition 1 signal parameter. Verify that the scan tool displays a value



that is within 2 V of the battery terminal voltage.



瀚慖f not within the specified range, replace the appropriate control module.

No comments:

Post a Comment