Thursday, January 16, 2020

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1508

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1508



* Crankshaft Position Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Crankshaft Position



Sensor/Service and Repair)



* Fuel Injector Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Fuel Injector/Service and Repair)



* Fuel Tank Pressure Sensor Replacement (See: Powertrain Management/Computers and Control Systems/Fuel Tank Pressure Sensor/Service



and Repair)



* Secondary Injection Shutoff Valve Pressure Sensor Replacement (See: Powertrain Management/Emission Control Systems/Air Injection/Air



Injection Check Valve/Service and Repair)



* Throttle Body Assembly Replacement (LF1) (See: Powertrain Management/Fuel Delivery and Air Induction/Throttle Body/Service and



Repair/Removal and Replacement)Throttle Body Assembly Replacement (LAU) (See: Powertrain Management/Fuel Delivery and Air



Induction/Throttle Body/Service and Repair/Removal and Replacement)



* Turbocharger Pressure Sensor Replacement (See: Powertrain Management/Fuel Delivery and Air Induction/Turbocharger/Service and



Repair/Turbocharger Pressure Sensor Replacement)



* Control Module References (See: Testing and Inspection/Programming and Relearning) for ECM replacement, setup, and programming



P0650



DTC P0650



Diagnostic Instructions



* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System



Check - Vehicle) prior to using this diagnostic procedure.



* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an



overview of the diagnostic approach.



* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure



Instructions) provides an overview of each diagnostic category.



DTC Descriptor



DTC P0650



- Malfunction Indicator Lamp (MIL) Control Circuit



Diagnostic Fault Information



Circuit/System Description



The malfunction indicator lamp (MIL) is located on the instrument panel cluster (IPC). The MIL informs the driver that an emission system fault



has occurred and that the engine control system requires service. The engine control module (ECM) monitors the MIL control circuit for conditions



that are incorrect for the commanded state of the MIL. For example, a failure condition exists if the ECM detects low voltage when the MIL is



commanded OFF, or high voltage when the MIL is commanded ON.



Conditions for Running the DTC



* The engine speed is greater than 80 RPM.



* The ignition voltage is between 10-18 V.



* The ECM has commanded the MIL ON and OFF at least once during the ignition cycle.



* DTC P0650 runs continuously when the above conditions are met.



Conditions for Setting the DTC



The ECM detects an open, a short to ground, or a short to voltage on the circuit that controls the MIL.



Action Taken When the DTC Sets



DTC P0650 is a Type B DTC.



Conditions for Clearing the DTC



DTC P0650 is a Type B DTC.



Diagnostic Aids



If the condition is intermittent, move the related harnesses and connectors with the engine operating. Monitor the scan tool Circuit Test Status

No comments:

Post a Comment