Tuesday, December 3, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1395

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1395



P0501



The ECM detects the CAN signal is not valid for more than 2 s.



P0503



The ECM detects the vehicle speed is greater than 275 km/h (171 MPH) for more than 0.2 s.



Action Taken When the DTC Sets



* DTC P0501 is a Type C DTC.



* DTC P0503 is a Type B DTC.



Conditions for Clearing the DTC



* DTC P0501 is a Type C DTC.



* DTC P0503 is a Type B DTC.



Reference Information



Schematic Reference



Automatic Transmission Controls Schematics (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Diagrams/Electrical



Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



Description and Operation



Transmission Component and System Description (See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Description and



Operation/AF40-6 - Automatic Transmission/Transmission Component and System Description)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information



Circuit/System Verification



1. Ignition On, observe the DTC information with a scan tool. Verify no TCM or communication DTCs are set.



瀚慖f any TCM or communication DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code



Descriptions/Diagnostic Trouble Code (DTC) List - Vehicle) for further diagnosis.



2. Raise the drive wheels.



Caution: Support the lower control arms in the normal horizontal position in order to avoid damage to the drive axles. Do not operate the



vehicle in gear with the wheels hanging down at full travel.



3. Support the lower control arms so that the drive axles are in a horizontal position.



4. Engine running, place the transmission into 2nd gear.



5. Observe the scan tool Vehicle Speed parameter. The following should display a similar vehicle speed once the drive wheels are at a speed



above 5 km/h (3 MPH):



* The scan tool Vehicle Speed parameter

No comments:

Post a Comment