Wednesday, December 18, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 966

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 966

C0201 04 or C120D

* The EBCM detects an open in the circuits to the solenoid valve relay.

* The EBCM detects a stuck open solenoid valve relay.

C0201 0E or C120D

* The EBCM detects an short to battery in the circuits to the solenoid valve relay.

* The EBCM detects a stuck closed solenoid valve relay.

Action Taken When the DTC Sets

* The EBCM disables the antilock brake system (ABS) and the vehicle stability enhancement system for the duration of the ignition cycle.

* A driver information center message and/or a warning indicator may be displayed.

Conditions for Clearing the DTC

* The condition for setting the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the EBCM.

2. Test for less than 1 ohm between the ground circuits listed below and ground.

* Terminal 13

* Terminal 38

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground.

* Terminal 1

* Terminal 25

瀚慖f the test lamp does not illuminate, test the appropriate circuit for a short to ground or an open/high resistance. If the circuit tests normal

and the B+ circuit fuse is open, replace the brake pressure modulator valve assembly.

4. If all circuits test normal, replace the EBCM and verify DTC does not reset. If the DTC resets, replace the brake pressure modulator valve

assembly.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

No comments:

Post a Comment