2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 661
Component Testing
Tilt Switch
1. Ignition OFF, disconnect the harness connector at the tilt switch.
2. Test for infinite resistance between the control terminals A and C with the switch in the neutral position.
瀚慖f less than the specified range, replace the tilt switch.
3. Test for less than 1 ohm between the control terminals listed below and the B+ terminal B with the switch in each appropriate position.
* Tilt Up Switch terminal C
* Tilt Down Switch terminal A
瀚慖f greater than the specified value, replace the tilt switch.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Steering Column Tilt Wheel Switch Replacement (See: Sensors and Switches/Sensors and Switches - Steering and Suspension/Sensors and
Switches - Steering/Tilt Wheel Switch/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming
B2880
DTC B2860 or B2880
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B2880 01
- Tilt Position Sensor Circuit Short to Battery
DTC B2880 06
- Tilt Position Sensor Circuit Short to Ground or Open
DTC B2880 5A
- Tilt Position Sensor Circuit Plausibility Failure
DTC B2880 61
- Tilt Position Sensor Actuator Stuck
Diagnostic Fault Information
Circuit Description
The memory seat module (MSM) determines the position of the steering column based on inputs received from the tilt position sensors built into
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Wednesday, December 4, 2019
2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 661
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment