2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 678
If any of the DTCs are set, replace the battery in the appropriate keyless entry transmitter. Operate the transmitter 3 consecutive times. If the DTC
resets, replace the keyless entry transmitter.
Repair Instructions
Important: This vehicle may be equipped with the 2-Way Advanced Remote Start System. Vehicle equipped with the 2-Way Advanced
Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label on the RCDLR. When servicing
the 2-Way Advanced Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the 2-Way
Advanced Remote Start System can be found in the Accessory section of the parts manual.
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Remote Control Door Lock Transmitter Programming (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless
Entry/Keyless Entry Transmitter/Testing and Inspection)
B3130
DTC B3130 or B3135
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B3130 00
- All Door Unlock Circuit
DTC B3135 00
- All Door Lock Circuit
Diagnostic Fault Information
Circuit/System Description
The LOCK/UNLOCK relay is controlled by the body control module (BCM) by providing voltage to one side of the relay or providing a ground to
the other side of the relay. During lock or unlock operation, battery voltage will be supplied to the lock actuators through the energized side of the
relay and grounded through the de-energized side of the relay.
Conditions for Running the DTC
The system voltage must be between 9-16 volts.
Conditions for Setting the DTC
B3130 00
The BCM detects a fault on the REAR DOOR LOCK/UNLOCK relay control circuit while commanding the rear doors to unlock.
No comments:
Post a Comment