2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 670
The transponder value measured by the TDM is incorrect or not learned to the vehicle.
Action Taken When the DTC Sets
* Vehicle starting will be disabled.
* The security indicator will be illuminated.
* The security indicator will flash (Canada only).
Conditions for Clearing the DTC
* A current DTC will be cleared when the TDM detects a valid transponder value from the ignition key.
* A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
Reference Information
Schematic Reference
Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and
Operation/Immobilizer Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Important: When using this diagnostic, more than one vehicle key is required to ensure proper diagnosis. If more than one key is not
available at the time of service, contact the customer and ask if any other keys can be provided for service. If unavailable, a new second
key can be created.
1. Perform the 10-Minute Vehicle Key Relearn procedure. Refer to Replacing Keys (North America except Canada) (See: Accessories and
Optional Equipment/Antitheft and Alarm Systems/Service and Repair/Replacing Keys (North America Except Canada)).
2. While viewing the scan tool TDM Valid Key parameter, turn ON the ignition with each of the available vehicle keys. The parameter should
read Yes with all available keys.
瀚慖f not the specified value, replace the appropriate key.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Replacing Keys (North America except Canada) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and
Repair/Replacing Keys (North America Except Canada))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for TDM replacement, setup, and programming
B3105
DTC B3105
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
No comments:
Post a Comment