2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 769

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 769

瀚慖f greater than the specified range, test the ground circuit for an open/high resistance.

3. Ignition ON, verify that a test lamp illuminates between the B+ circuits listed below and ground.

* Terminal 1

* Terminal 25

瀚慖f the test lamp does not illuminate, test the appropriate circuit for a short to ground or an open/high resistance.

4. If all circuits test normal, replace the EBCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming

Brake Boost Solenoid

DTC C012F, C12A7, C12DC, or C12DD

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C012F 00

- Brake Boost Solenoid Valve Circuit

DTC C012F 0E

- Brake Boost Solenoid Valve Circuit Shorted

DTC C12A7

- Brake Boost Solenoid Valve Circuit Performance

DTC C12DC

- Brake Boost Solenoid Valve Circuit Malfunction

DTC C12DD

- Brake Boost Solenoid Valve Circuit Shorted

Circuit/System Description

The electronic brake control module (EBCM) uses input from the boost pressure sensor for more accurate control during brake and vehicle stability

enhancement system (VSES) event. The boost pressure sensor is internal to the brake pressure modulator valve (BPMV).

Conditions for Running the DTC

* The ignition is ON.

* Ignition voltage is greater than 10 volts.

Conditions for Setting the DTC

C012F 00, C12A7, C12DC

Solonoid feedback current greater than 25% of commanded current.

C012F 0E, C12DD

Solonoid feedback current greater than 50% of requested current.

Action Taken When the DTC Sets