2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 794
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
1. Using a scan tool, perform the EBCM, Module Setup, EBCM Relearn.
2. Verify that DTC C012C, C121A, C128C, C128F, C12B9, C12BA, C12BB or C12F7 is not set.
瀚慖f the DTC is set replace brake pressure modulator valve assembly. If the DTC resets, replace the EBCM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Brake Pressure Modulator Valve Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Hydraulic
Control Assembly - Antilock Brakes/Service and Repair)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, programming and setup
C012C
DTC C012C, C121A, C128C, C128F, C12B9, C12BA, C12BB, or C12F7
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C12F7
- ABS Boost Pressure Sensor and Regenerative Axle Pressure Sensor Not Plausible
DTC C128F
- ABS Regenerative Axle Pressure Sensor Raw Offset Error
DTC C012C 01
- Regenerative Axle Pressure Sensor Short to Battery
DTC C12BA
- ABS Regenerative Axle Pressure Sensor Circuit Short To Battery
DTC C012C 06
- Regenerative Axle Pressure Sensor Short to Ground or Open
DTC C12B9
- ABS Regenerative Axle Pressure Sensor Circuit Open or Short To Ground
DTC C012C 11
- Regenerative Axle Pressure Sensor Above Maximum Threshold
DTC C128C
- ABS Regenerative Axle Pressure Sensor Offset Error
DTC C012C 0F
- Regenerative Axle Pressure Sensor Erratic
No comments:
Post a Comment