2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 753

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 753

The voltage on any power rail 1 motor control circuit exceeds 2.78 V for 100 ms.

B3920 02

The voltage on any power rail 1 motor control circuit is below 1.47 V for 100 ms.

B3921 01

The voltage on any power rail 2 motor control circuit exceeds 2.78 V for 100 ms.

B3921 02

The voltage on any power rail 2 motor control circuit is below 1.47 V for 100 ms.

Action Taken When the DTC Sets

The MSM will not allow operation of any motor on the power rail for which the DTC was set.

Conditions for Clearing the DTC

* The current DTC clears when the malfunction is no longer present and the power mode changes to OFF then back to ACC or RUN.

* A history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

* Driver Seat Schematics ()

* Passenger Seat Schematics ()

* Adjustable Pedal Schematics (See: Accessories and Optional Equipment/Pedal Positioning System/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Memory Seats Description and Operation ()

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

B3920 01 or B3920 02

1. Ignition OFF, disconnect the X1 harness connector at the MSM.

2. Ignition ON, verify that a test lamp does not illuminate between the control circuits listed below and ground:

* Front vertical motor terminal 12

* Front vertical motor terminal 13

* Rear vertical motor terminal 15

* Rear vertical motor terminal 16

* Seat horizontal motor terminal 9

* Seat horizontal motor terminal 10

瀚慖f the test lamp illuminates, test the control circuit for a short to voltage.

3. Test for infinite resistance between the control circuits listed below and ground:

* Front vertical motor terminal 12