2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 762
Circuit/System Description
When the theft deterrent module (TDM) is in the learn coded key state, the TDM checks the current key to ensure it has been configured as a proper
vehicle key.
Conditions for Running the DTC
* Ignition is in the Accessory or Run position.
* The TDM is in the learn coded key state.
Conditions for Setting the DTC
The TDM has determined the current key is not configured as a proper vehicle key.
Action Taken When the DTC Sets
* The security indicator will be illuminated.
* Vehicle starting will be disabled.
Conditions for Clearing the DTC
* A current DTC will be cleared when the TDM detects a properly configured vehicle key.
* A history DTC will be cleared after 100 malfunction-free ignition cycles or when a scan tool is used to clear DTCs.
Reference Information
Schematic Reference
Immobilizer Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Diagrams/Electrical Diagrams/Immobilizer
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Immobilizer Description and Operation (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Description and
Operation/Immobilizer Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Important: When using this diagnostic, more than one vehicle key is required to ensure proper diagnosis. If more than one key is not
available at the time of service, contact the customer and ask if any other keys can be provided for service. If unavailable, a new second
key can be created.
While viewing DTCs with a scan tool, attempt to start the vehicle using all of the available keys. The vehicle should start with all available keys.
If any key results in inoperative starting and DTC B3976 is set, replace the appropriate key.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Replacing Keys (North America except Canada) (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Service and
Repair/Replacing Keys (North America Except Canada))
No comments:
Post a Comment