Friday, November 15, 2019

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1432

2010 Cadillac Truck SRX AWD V6-2.8L Turbo Page 1432



Circuit/System Description



The cruise control switch is an input to the body control module (BCM). The BCM monitors the cruise control on/off, set/coast, resume/accelerate



and cancel switches via the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function.



The BCM detects a specific voltage signal on the cruise control switch signal circuit when a switch is applied. The BCM sends a serial data



message to the engine control module (ECM) indicating the status of the cruise control switches.



Conditions for Running the DTC



* The cruise switch is ON.



* The ignition is ON.



Conditions for Setting the DTC



* The BCM detects an invalid voltage signal on the cruise control switch signal circuit for greater than 2 seconds and sends a serial data



message to the ECM. The ECM sets these DTCs when the message is received.



* The ECM runs this diagnostic every 0.05 second.



Actions Taken When the DTC Sets



DTCs P0564, P0567, or P0568 are type C DTCs.



Conditions for Clearing the DTC



DTCs P0564, P0567, or P0568 are type C DTCs.



Reference Information



Schematic Reference



Cruise Control Schematics (See: Cruise Control/Diagrams/Electrical Diagrams)



Connector End View Reference



Component Connector End Views (See: Diagrams/Connector Views/Connector End Views By Name)



Description and Operation



Cruise Control Description and Operation (See: Cruise Control/Description and Operation)



Electrical Information Reference



* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit



Testing/Circuit Testing)



* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic



Procedures/Connector Repairs/Connector Repairs)



* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General



Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)



* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring



Repairs/Wiring Repairs)



DTC Type Reference



Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code



(DTC) Type Definitions)



Scan Tool Reference



Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information



Circuit/System Verification



Engine ON, while rotating the steering wheel to both steering stops, observe the scan tool Cruise Control Switch parameter while pressing each of



the cruise control switches. The parameter should toggle between On, Off, Resume, Set, and Cancel as the applicable switch is pressed.



Circuit/System Testing



1. Ignition OFF, disconnect the harness connector at the S70L steering wheel control switch-left.



2. Ignition ON, test for B+ between the B+ circuit terminal 1 and ground.



瀚慖f less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9



BCM.



3. Test for B+ between the B+ circuit terminal 1 and the signal circuit terminal 2.

No comments:

Post a Comment