2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 416
DTC B1287 02
- Amplifier Control Signal Circuit Short to Ground
DTC B1287 04
- Amplifier Control Signal Circuit Open
Diagnostic Fault Information
Circuit/System Description
The radio provides a remote amplifier mute output circuit to control overall muting of the remote amplifier. The amplifier receives pulse width
modulated (PWM) signals on the control circuit at varying duty cycle percentages for controlling muted and unmuted functions of the amplifier.
Circuitry internal to the radio monitors the remote amplifier mute circuit for faults and sets the appropriate DTC when faults are detected.
Conditions for Running the DTC
* Radio is ON
* The system voltage is at between 9 volts and 16 volts
Conditions for Setting the DTC
A short to voltage, short to ground, or an open is seen on the remote enable circuit
Action Taken When the DTC Sets
Amplifier functions are disabled
Conditions for Clearing the DTC
* A current DTC clears when the condition for setting the DTC is no longer present
* A history DTC clears after 100 malfunction-free ignition cycles
Reference Information
Schematic Reference
Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Radio/Audio System Description and Operation (See: Accessories and Optional Equipment/Description and Operation/Radio/Audio System
Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Radio ON, adjust the fade and balance control to verify audio is present at each individual channel.
Circuit/System Testing
No comments:
Post a Comment