2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 292

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 292

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. With a master vehicle key, turn the ignition ON.

2. Observe the security indicator. After approximately 10 minutes, the indicator will turn off.

3. Turn the ignition OFF and wait 5 seconds.

4. Repeat steps 2-4 two more times for a total of 3 cycles or 30 minutes.

5. With a master vehicle key, turn the ignition ON. The start disable will now be cleared.

6. Using the Red Emergency Button, notify the advisor that the Ignition Block on the vehicle has been cleared and to update the account status.

B320A

DTC B320A

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptors

DTC B320A 39

- Front Door Window Motor Internal Electronic Failure

DTC B320A 42

- Front Door Window Motor Calibration Data Set Not Programmed

DTC B320A 4B

- Front Door Window Motor Calibration Not Learned

Diagnostic Fault Information