Sunday, November 24, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 431

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 431

Conditions for Running the DTC

* The system voltage is between 9-16 V.

* The ignition switch is ON.

Conditions for Setting the DTC

A short to ground or an open on the wake up signal circuit.

Action Taken When the DTC Sets

The modules is never signaled, therefore the specific subsystems will not function.

Conditions for Clearing the DTC

* A current DTC clears when the malfunction is no longer present.

* A history DTC clears when the module ignition cycle counter reaches the reset threshold of 50, without a repeat of the malfunction.

Circuit/System Verification

Verify that DTCs U1814, U1812, and U209A are not set.

If any of the DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle (See: Diagnostic Trouble Code Descriptions/Diagnostic

Trouble Code (DTC) List - Vehicle).

BCM

DTC B1380 (BCM)

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B1380 01

- Device Ignition ACCESSORY Circuit Short to Battery

DTC B1380 06

- Device Ignition ACCESSORY Circuit Short to Ground or Open

Diagnostic Fault Information

No comments:

Post a Comment