2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 418
Action Taken When the DTC Sets
The radio sets the DTC and defaults the video display to normal mode.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Video System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Video System Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Video Entertainment System Description and Operation (Non-Headrest DVD Systems) (See: Accessories and Optional Equipment/Description
and Operation/Video Entertainment System Description and Operation (Non-Headrest DVD Systems))Video Entertainment System Description
and Operation (Dual Headrest DVD Systems) (See: Accessories and Optional Equipment/Description and Operation/Video Entertainment System
Description and Operation (Dual Headrest DVD Systems))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the rear video display.
2. Ignition ON, test for 100-300 Hz at the control circuit terminal 10.
瀚慖f not within the specified range, test the control circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit
tests normal, replace the radio.
3. If all circuits test normal, replace the rear video display.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Video Display Replacement (Second Row) (See: Accessories and Optional Equipment/Entertainment Systems/Television / Monitor/Service
and Repair/Video Display Replacement (Second Row))Video Display Replacement (Third Row) (See: Accessories and Optional
Equipment/Entertainment Systems/Television / Monitor/Service and Repair/Video Display Replacement (Third Row))
* Control Module References (See: Testing and Inspection/Programming and Relearning) for Radio replacement, setup, and programming
B1289
DTC B1289
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
No comments:
Post a Comment