2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 541

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 541

Action Taken When the DTC Sets

The heated seat function for both seats will be disabled.

Conditions for Clearing the DTC

* The current DTC clears when the malfunction is no longer present and the power mode changes to OFF then back to ACC or RUN.

* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Heated/Cooled Seat Schematics ()

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Heated Seats Description and Operation (KA1) ()Heated Seats Description and Operation (KA6) ()

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

B2345 00

1. Ignition OFF, disconnect the X1 harness connector at the HSM.

2. Test for infinite resistance between the control circuit terminal 3 and ground.

瀚慖f not the specified value, test the control circuits listed below for a short to ground:

* Driver seat cushion and seat back element terminal 3

* Driver seat cushion element terminal 5

* Driver seat back element terminal 1

3. Test for infinite resistance between the control circuit terminal 6 and ground.

瀚慖f not the specified value, test the control circuits listed below for a short to ground:

* Passenger seat cushion and seat back element terminal 6

* Passenger seat cushion element terminal 2

* Passenger seat back element terminal 4

4. Ignition ON, verify that a test lamp does not illuminate between the control circuit terminal 3 and ground.

瀚慖f the test lamp illuminates, test the control circuits listed below for a short to voltage:

* Driver seat cushion and seat back element terminal 3

* Driver seat cushion element terminal 5

* Driver seat back element terminal 1

5. Verify that a test lamp does not illuminate between the supply voltage circuit terminal 6 and ground.

瀚慖f the test lamp illuminates, test the control circuits listed below for a short to voltage:

* Passenger seat cushion and seat back element terminal 6

* Passenger seat cushion element terminal 2

* Passenger seat back element terminal 4