2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 218

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 218

* Right rear side impact sensor terminal B

* Left rear side impact sensor terminal B

瀚慖f greater than the specified range, test the circuit for a short to voltage.

4. Ignition ON, test for less than 1 volt between the low reference circuit and ground.

* Right front end sensor terminal 2

* Left front end sensor terminal 2

* Right front side impact sensor terminal A

* Left front side impact sensor terminal A

* Right rear side impact sensor terminal A

* Left rear side impact sensor terminal A

瀚慖f greater than the specified range, test the circuit for a short to voltage.

5. Test for infinite resistance between the signal circuit and ground.

* Right front end sensor terminal 1

* Left front end sensor terminal 1

* Right front side impact sensor terminal B

* Left front side impact sensor terminal B

* Right rear side impact sensor terminal B

* Left rear side impact sensor terminal B

瀚慖f less than the specified value, test the circuit for a short to ground.

6. Test for less than 1 ohm between the following signal circuit terminals.

* Right front end sensor terminal 1 and SDM terminal 37.

* Left front end sensor terminal 1 and SDM terminal 36.

* Right front side impact sensor terminal B and the SDM terminal 43.

* Left front side impact sensor terminal B and the SDM terminal 42.

* Right rear side impact sensor terminal B and the SDM terminal 45.

* Left rear side impact sensor terminal B and the SDM terminal 44.

瀚慖f greater than the specified range, test the circuit for an open/high resistance.

7. Test for less then 1 ohm between the following front end sensor low reference circuit terminals.

* Right front end sensor terminal 2 and SDM terminal 39.

* Left front end sensor terminal 2 and SDM terminal 38.

* Right front side impact sensor terminal A and the SDM terminal 41.

* Left front side impact sensor terminal A and the SDM terminal 40.

* Right rear side impact sensor terminal A and the SDM terminal 47.

* Left rear side impact sensor terminal A and the SDM terminal 46.

瀚慖f greater than the specified range, test the circuit for an open/high resistance.

8. If all circuits test normal, replace the appropriate sensor.

9. Reconnect all SIR components. Ignition ON, with a scan tool clear and check for DTCs.

瀚慖f the DTC returns and is current, replace the SDM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Inflatable Restraint Front End Sensor Replacement (See: Restraints and Safety Systems/Air Bag Systems/Impact Sensor/Service and

Repair/Inflatable Restraint Front End Sensor Replacement)

* Inflatable Restraint Side Impact Sensor Replacement (Front Side Door) (See: Restraints and Safety Systems/Air Bag Systems/Impact

Sensor/Service and Repair/Inflatable Restraint Side Impact Sensor Replacement (Front Side Door))Inflatable Restraint Side Impact Sensor

Replacement (Rear Side Door) (See: Restraints and Safety Systems/Air Bag Systems/Impact Sensor/Service and Repair/Inflatable Restraint

Side Impact Sensor Replacement (Rear Side Door))

* SIR/SRS Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Wiring Repairs/SIR/SRS Wiring Repairs)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for SDM replacement, setup, and programming