2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 343

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 343

3. Ignition OFF, connect the harness connector at the I/P multifunction switch. Disconnect the X1 harness connector at the object alarm module.

4. Ignition ON, verify the park assist disable LED is not illuminated.

瀚慖f the LED is illuminated, test the control circuit for a short to ground. If the circuit tests normal, test or replace the I/P multifunction

switch.

5. Install a 10A fused jumper wire between the control circuit terminal 3 and ground. Verify that the park assist disable LED is illuminated.

瀚慖f the LED is not illuminated, test the control circuit for a short to voltage or an open/high resistance. If the circuit tests normal, test or

replace the I/P multifunction switch.

6. If all circuits test normal, replace the object alarm module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Rear Object Alarm Module Switch Replacement (Escalade) (See: Accessories and Optional Equipment/Collision Avoidance and Parking

Assist Systems/Parking Assist Switch/Service and Repair/Rear Object Alarm Module Switch Replacement (Escalade))Rear Object Alarm

Module Switch Replacement (Tahoe/Yukon) (See: Accessories and Optional Equipment/Collision Avoidance and Parking Assist

Systems/Parking Assist Switch/Service and Repair/Rear Object Alarm Module Switch Replacement (Tahoe/Yukon))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for Object Alarm Module replacement, setup, and

programming.

B1000

DTC B1000

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B1000 00

- Electronic Control Unit (ECU) Performance No Additional Information Available

DTC B1000 04

- Side Object Detection Performance - RAM Failure

DTC B1000 08

- Electronic Control Unit (ECU) Performance Signal Invalid

DTC B1000 12

- Electronic Control Unit (ECU) Performance Below Minimum Threshold

DTC B1000 31

- Electronic Control Unit (ECU) General Checksum Problem

DTC B1000 32

- Electronic Control Unit (ECU) General Memory Failure

DTC B1000 33

- Electronic Control Unit (ECU) Performance Special Memory Failure

DTC B1000 34

- Electronic Control Unit (ECU) Performance RAM Integrity

DTC B1000 35

- Electronic Control Unit (ECU) Performance ROM Integrity

DTC B1000 36

- Electronic Control Unit (ECU) Performance EEPROM Integrity