2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 457
Diagnostic Aids
Many controllers such as the power inverter module (PIM), transmission control module (TCM), and inflatable restraint sensing and diagnostic
module (SDM) will set a DTC for a problem with the Run and Crank/On and Start Power Voltage circuit. Confirm that they do not have DTCs
before only investigating the SDGM.
Reference Information
Schematic Reference
Hybrid Controls Schematics (See: Hybrid Drive Systems/Diagrams/Electrical Diagrams)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Drive Motor Generator Control Module Description and Operation (See: Hybrid Drive Systems/Power Control System/Drive Motor Control
Module/Description and Operation)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Testing
1. Ignition OFF, disconnect the SDGM harness connector X2 at the SDGM, verify that a test lamp does not illuminate between the ignition
circuit terminal 20 and ground.
瀚慖f the test lamp illuminates, test the signal circuit terminal 20 for a short to voltage.
2. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal 20 and ground.
瀚慖f the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
3. If all circuits test normal, replace the SDGM.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
Control Module References (See: Testing and Inspection/Programming and Relearning) for SDGM replacement, setup, and programming
B1475
DTC B1475
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B1475 00
- Retained Accessory Power Circuit
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Monday, November 25, 2019
2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 457
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment