Wednesday, November 20, 2019

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 348

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 348

DTC Descriptor

DTC B1008 00

- Calibration Data Not Programmed

Circuit/System Description

When replacing a remote control door lock receiver (RCDLR), the service replacement part is shipped with no installed software. Before the new

RCDLR is operational, a software calibration is required to be downloaded using the SPS terminal. Failure to download this software calibration

will result in the setting of DTC B1008.

Conditions for Running the DTC

This DTC runs continuously

Conditions for Setting the DTC

The RCDLR has no calibration loaded.

Action Taken When the DTC Sets

All functions handled by the RCDLR are inoperative

Conditions for Clearing the DTC

A current DTC will clear when software calibrations are installed.

Reference Information

Schematic Reference

Remote Function Schematics (See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry

Transmitter/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Keyless Entry System Description and Operation (Without Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and

Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (Without Accessory 2 Way Remote)

)Keyless Entry System Description and Operation (With Accessory 2 Way Remote) (See: Accessories and Optional Equipment/Antitheft and

Alarm Systems/Keyless Entry/Description and Operation/Keyless Entry System Description and Operation (With Accessory 2 Way Remote))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Perform the RCDLR Programming and Setup procedure. Refer to Remote Control Door Lock Receiver Programming and Setup (See: Accessories

and Optional Equipment/Antitheft and Alarm Systems/Keyless Entry/Keyless Entry Receiver/Testing and Inspection).

If the DTC resets, replace the RCDLR.

Repair Instructions

Important: This vehicle may be equipped with the 2 Way Advanced Remote Start System. Vehicle equipped with the 2 Way Advanced

Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label on the RCDLR. When servicing

the 2 Way Advanced Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the 2 Way

Advanced Remote Start System can be found in the Accessory section of the parts manual.

No comments:

Post a Comment