2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 497

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 497

瀚慖f not the specified value, test the appropriate signal circuit listed below for a short to voltage. If the circuit tests normal, replace the

MSM.

* Front vertical upward switch terminal A

* Front vertical downward switch terminal K

* Rear vertical upward switch terminal F

* Rear vertical downward switch terminal J

* Horizontal forward switch terminal D

* Horizontal rearward switch terminal C

* Recline forward switch terminal H

* Recline rearward switch terminal G

3. If all circuits test normal, test or replace the seat adjuster switch.

Component Testing

1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.

2. Test for infinite resistance between each seat direction signal terminal listed below and the B+ terminal E with the switch in the open

position.

* Front vertical upward switch terminal A

* Front vertical downward switch terminal K

* Rear vertical upward switch terminal F

* Rear vertical downward switch terminal J

* Horizontal forward switch terminal D

* Horizontal rearward switch terminal C

* Recline forward switch terminal H

* Recline rearward switch terminal G

瀚慖f not the specified value, replace the seat adjuster switch.

3. Test for less than 1 ohm between each seat direction signal terminal listed below and the B+ terminal E with the switch in the closed position.

* Front vertical upward switch terminal A

* Front vertical downward switch terminal K

* Rear vertical upward switch terminal F

* Rear vertical downward switch terminal J

* Horizontal forward switch terminal D

* Horizontal rearward switch terminal C

* Recline forward switch terminal H

* Recline rearward switch terminal G

瀚慖f greater than the specified range, replace the adjuster switch switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Power Seat Switch Replacement (with HP2) ()Power Seat Switch Replacement (without HP2) ()

* Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming

B1755

DTC B1735, B1740, B1745, B1750, B1755, B1760, B1815, or B1820

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B1735 01

- Seat Front Up Switch Circuit Short to Battery