2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 493

2010 Cadillac Truck Escalade RWD V8-6.0L Hybrid Page 493

Circuit Description

When the power seat switches are pressed, they send a 12-volt signal through the switch signal circuits to the memory seat module (MSM). The

MSM then commands the driver seat motors to move in response to the switch signals.

Conditions for Running the DTC

The memory seat module must be powered.

Conditions for Setting the DTC

* If a seat switch circuit is active in one direction and the switch for the opposite direction is pressed, this DTC will set.

* Multiple DTCs will set if one of the switch signal circuits is shorted to voltage.

Action Taken When the DTC Sets

* A motor output driven in response to a switch considered failed, is deactivated for both directions.

* All memory recall commands are ignored.

* The MSM will respond to any other switch signal that has not set a DTC.

Conditions for Clearing the DTC

* The current DTC will clear and set the code to history, 3 seconds after the fault is no longer present and the ignition is cycled OFF then back

to ACC or RUN.

* A history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Driver Seat Schematics ()

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Memory Seats Description and Operation ()

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)