2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 728
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Ignition ON, command the liftglass latch to release the liftglass by pressing the liftgate window release switch. The liftglass latch should release the
liftglass.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the rear window wiper motor.
2. Ignition ON, connect a test lamp between the signal circuit terminal B and ground.
3. Command the liftglass latch to release by pressing the liftgate window release switch. The test lamp should briefly illuminate when the
liftgate window release switch is pressed.
瀚慖f the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace
the BCM.
瀚慖f the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the BCM.
4. If all circuits test normal, replace the rear window wiper motor.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.
* Rear Window Wiper Motor Replacement (See: Wiper and Washer Systems/Wiper Motor/Service and Repair/Rear Window Wiper Motor
Replacement)
* Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement and setup procedures
B3445
DTC B3445
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC B3445 00
- Stop Lamp Circuit
Diagnostic Fault Information
Mercedes Benz Diagnostic and Repair Information ,Wiring Diagrams. DTC. TSB. Types: TSB, DTC, Wiring Diagrams, OEM Procedures. Trusted by more than 400,000 technicians. OEM accurate fix for faster repairs. Repair Procedures and Labor Times. Factory Auto Repair info. Request A Demo Today. Factory-Correct Diagrams. Factory Part Numbers. Maintenance Schedules. Repair Procedures. Labor Times. Types: TSB, DTC.Mercedes,Mercedes,Benz,Mercedes-Benz UK,A,Class,B,Class,C,Class,E,Class,CLA,CLS,G,Class,GLA,A
Saturday, November 16, 2019
2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 728
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment