2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 462

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 462

Conditions for Setting the DTC

B1395 03

The BCM detects a voltage that is lower than 0.33 V on the I/P dimming voltage reference circuit.

B1395 07

The BCM detects a voltage that is greater than 4.97 V on I/P dimming voltage reference circuit.

Action Taken When the DTC Sets

* The I/P lamps are dim or not illuminated.

* The I/P lamps will not dim.

* The stop lamps are always ON.

Conditions for Clearing the DTC

* The conditions for setting the DTC are no longer present.

* A history DTC clears after 100 malfunction-free ignition cycles.

* The BCM receives the clear code command from the scan tool.

Reference Information

Schematic Reference

* Interior Lights Dimming Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Interior Lights Dimming

Schematics)

* Exterior Lights Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System Diagram/Exterior Lights Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Interior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Interior Lighting Systems Description

and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the headlamp and panel dimmer switch.

2. Ignition OFF, verify that a test lamp illuminates between the ground circuit terminal 8 and B+.

瀚慖f the test lamp does not illuminate, test the ground circuit for an open/high resistance.

3. Ignition ON, verify the scan tool Dimming Control Signal parameter is less than 0.1 V.

瀚慖f greater than the specified range, test the signal circuit terminal 13 for a short to voltage. If the circuit tests normal, replace the BCM.

4. Ignition ON, test for 12 V between the I/P dimming voltage reference circuit terminal 15 and ground.

瀚慖f less than the specified value, test the voltage reference circuit for a short to ground or an open/high resistance. If the circuit tests

normal, replace the BCM.

5. Install a 3 A fused jumper wire between the signal circuit terminal 13 and the voltage reference circuit terminal 15. Verify the scan tool BCM

Dimming Control Signal parameter is greater than 2.6 V.