2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1211
* The vent fan blades are not broken or damaged.
* The internal foam seals are not missing or damaged.
瀚慖f any conditions are found, remove, repair or replace as necessary.
3. Ignition OFF, disconnect the X3 harness connector at the drive motor generator battery control module.
Note: The following test must be performed when the battery pack has equalized at room temperature. An increase or decrease in
temperature will cause resistance to change and may result in invalid test results.
4. Test for 1k ohm-209k ohm between the terminals listed below. The resistance of each temperature sensor should be within the specified
range, and within 500 ohm of each other. Refer to Temperature Versus Resistance ().
* Sensor 1-5 V reference circuit terminal 1 and low reference circuit terminal 2
* Sensor 2-5 V Reference circuit terminal 3 and low reference circuit terminal 4
* Sensor 3-5 V Reference circuit terminal 5 and low reference circuit terminal 6
* Sensor 4-5 V Reference circuit terminal 7 and low reference circuit terminal 8
瀚慖f not within the specified range, replace the drive motor battery sensor module wiring harness.
5. If all circuits test normal, replace the drive motor generator battery control module.
Repair Instructions
Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.
* Drive Motor Battery Sensor Module Wiring Harness Replacement ()
* Control Module References (See: Testing and Inspection/Programming and Relearning) for drive motor generator battery control module
replacement, setup and programming
P0A8D
DTC P0A8D
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0A8D
- 14 Volt Power Module System Voltage Low
Diagnostic Fault Information
Circuit/System Description
The Accessory Power Module (APM) continuously monitors its 14-volt circuit during charge or Jump Assist. This DTC sets when the 14-volt
circuit in the APM drops below a set level. APM functions will run only when an APM enable message from the Hybrid powertrain control module
(HPCM) is active on the high speed hybrid GMLAN communication circuit.
Conditions for Running the DTC
APM is charging or in Jump Assist.
Conditions for Setting the DTC
14-volt circuit is below 10.0 volts during charge or Jump Assist.
No comments:
Post a Comment