Sunday, November 17, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 809

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 809

* If 2 or more wheel speed sensors are inoperative diagnose each wheel speed sensor individually.

* An ECE 13 response may be required, after repairs are made, and DTCs are cleared, operate the vehicle at speeds greater than 15 km/h (10

mph) to complete the self test, and the EBCM will turn off the ABS indicator.

If the customer comments that the ABS indicator is ON only during moist environmental conditions: rain, snow, vehicle wash, etc., inspect the

wheel speed sensor wiring for signs of water intrusion. If the DTC is not current, clear all DTCs and simulate the effects of water intrusion by using

the following procedure:

1. Spray the suspected area with a 5 percent saltwater solution. To create a 5 percent saltwater solution, add 2 teaspoons of salt to 8 fl oz of

water (10 g of salt to 200 ml of water).

2. Test drive the vehicle over various road surfaces: bumps, turns, above 40 km/h (25 mph) for at least 30 seconds.

3. Rinse the area thoroughly when completed.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Observe the scan tool Wheel Speed Sensor parameter. The reading should be the same speed on all sensors when driving in a straight line at a

speed greater than 20 km/h (13 mph).

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the EBCM.

2. Ignition ON, test for less than 1 V between the 12 V reference circuit terminal of the appropriate sensor listed below and ground.

* Left Front Sensor circuit terminal 21

* Right Front Sensor circuit terminal 18

* Left Rear Sensor circuit terminal 33

* Right Rear Sensor circuit terminal 19

瀚慖f greater than the specified range, test the 12 V reference circuit for a short to voltage.

3. Test for less than 1 V between the signal circuit terminal of the appropriate sensor listed below and ground.

* Left Front Sensor circuit terminal 34

* Right Front Sensor circuit terminal 6

* Left Rear Sensor circuit terminal 20

* Right Rear Sensor circuit terminal 31

瀚慖f greater than the specified range, test the signal circuit for a short to voltage.

4. Ignition OFF, test for infinite resistance between the 12 V reference terminal of the appropriate sensor circuit listed below and ground.

* Left Front Sensor circuit terminal 21

* Right Front Sensor circuit terminal 18

* Left Rear Sensor circuit terminal 33

No comments:

Post a Comment