Monday, November 18, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 880

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 880

module has been replaced, ensure that the programming procedure and all recalibration procedures have been completed successfully before

addressing these DTCs.

Reference Information

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

1. Ignition ON, verify that the DTC is set as current and that no other vehicle system DTCs exists.

瀚慖f other vehicle system DTCs exists, address these DTCs before proceeding with this diagnostic test.

2. Cycle the ignition OFF then ON, clear the DTC with a scan tool and verify that the DTC does not reset as current.

瀚慖f the DTC resets as current, replace the BCM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

Control Module References (See: Testing and Inspection/Programming and Relearning) for BCM replacement, setup, and programming

C0292

DTC C0292

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C0292 02

- VSES Combination Sensor Circuit Short to Ground

DTC C0292 07

- VSES Combination Sensor Circuit Voltage Above Threshold

Circuit/System Description

The electronic brake control module (EBCM) supplies a ignition voltage of 12 volts to the yaw rate sensor/lateral accelerometer sensor. The sensor

supply voltage is monitored via an internal feedback circuit to the EBCM microprocessor.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

No comments:

Post a Comment