2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1465

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1465

- Wear the Insulation gloves at all times when working with the high voltage battery assembly, whether the system is energized or

not.

Failure to follow the procedures exactly as written may result in serious injury or death.

1. Ignition OFF, disable the high voltage at the drive motor generator battery. Refer to High Voltage Disabling ().

2. Disconnect the X4 harness connector at the drive motor battery control module.

3. Connect the EL-48571 high voltage battery pin out box.

4. Install the high voltage manual disconnect lever. Measure and record each of the 20 battery voltages.

5. Each battery voltage reading should be between 10-19 V.

瀚慖f not within the specified range, replace the drive motor battery assembly.

6. Each battery voltage reading should be within 1.5 V of each other.

瀚慖f not within the specified range, replace the drive motor battery assembly.

7. If all circuits test normal, replace the drive motor generator battery control module.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the repair.

* Drive Motor Generator Battery Replacement and Shipping Preparation ()

* Control Module References (See: Testing and Inspection/Programming and Relearning) for drive motor generator battery control module

replacement, setup and programming

P0B84

DTC P0B3E, P0B43, P0B48, P0B4D, P0B52, P0B57, P0B5C, P0B61, P0B66, P0B6B, P0B70, P0B75, P0B7A, P0B7F, P0B84, P0B89, P0B8E,

P0B93, P0B98, or P0B9D

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC P0B3E

- Hybrid Battery 1 Circuit High Voltage

DTC P0B43

- Hybrid Battery 2 Circuit High Voltage

DTC P0B48

- Hybrid Battery 3 Circuit High Voltage

DTC P0B4D

- Hybrid Battery 4 Circuit High Voltage

DTC P0B52

- Hybrid Battery 5 Circuit High Voltage

DTC P0B57

- Hybrid Battery 6 Circuit High Voltage

DTC P0B5C

- Hybrid Battery 7 Circuit High Voltage

DTC P0B61

- Hybrid Battery 8 Circuit High Voltage

DTC P0B66

- Hybrid Battery 9 Circuit High Voltage