2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 632

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 632

Circuit/System Description

The Bluetooth (R) antenna is a small fixed antenna connected directly to the communication interface module (CIM) and is used to send and

receive signals from a Bluetooth (R) enabled cellular phone. The antenna utilizes no cabling and is not external to the vehicle.

Conditions for Running the DTC

* Ignition ON.

* Battery voltage must be between 9-16 V.

* The CIM tests the antenna once every second.

Conditions for Setting the DTC

B2485 02

The CIM detects a short to ground in the Bluetooth (R) antenna.

B2485 04

The CIM detects an open/high resistance in the Bluetooth (R) antenna.

Actions Taken When the DTC Sets

* The OnStar (R) status LED turns red.

* Bluetooth (R) functionality is disabled.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 50 consecutive malfunction-free ignition cycles have occurred.

Schematic Reference

OnStar Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/OnStar Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

OnStar Description and Operation (See: Accessories and Optional Equipment/Description and Operation/OnStar Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Verify the Bluetooth (R) antenna is properly connected to the CIM and is not damaged.

瀚慖f the antenna is disconnected or damaged, repair or replace as necessary.

2. Ignition ON, verify the DTC B2485 is not set.

瀚慖f the DTC is set, replace the Bluetooth (R) antenna. Clear the DTC and cycle the ignition OFF then back ON. If the DTC resets as

current, replace the CIM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.