Sunday, November 10, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 226

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 226

Circuit/System Testing

Important: Refer to SIR Service Precautions (See: Restraints and Safety Systems/Air Bag Systems/Service Precautions/Technician

Safety Information).

When removing connectors, inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of

the affected component/connector:

* Front end sensor

* SDM module

* Front end sensor wiring harness connector

* SDM wiring harness connector

1. Ignition OFF, disconnect the harness connector at the appropriate sensor.

2. Disconnect the harness connector at the SDM.

3. Ignition ON, test for less than 1 volt between the following signal circuit and ground.

* Right front end sensor terminal 1

* Left front end sensor terminal 1

* Right front side impact sensor terminal B

* Left front side impact sensor terminal B

* Right rear side impact sensor terminal B

* Left rear side impact sensor terminal B

瀚慖f greater than the specified range, test the circuit for a short to voltage.

4. Ignition ON, test for less than 1 volt between the low reference circuit and ground.

* Right front end sensor terminal 2

* Left front end sensor terminal 2

* Right front side impact sensor terminal A

* Left front side impact sensor terminal A

* Right rear side impact sensor terminal A

* Left rear side impact sensor terminal A

瀚慖f greater than the specified range, test the circuit for a short to voltage.

5. Test for infinite resistance between the signal circuit and ground.

* Right front end sensor terminal 1

* Left front end sensor terminal 1

* Right front side impact sensor terminal B

* Left front side impact sensor terminal B

* Right rear side impact sensor terminal B

* Left rear side impact sensor terminal B

瀚慖f less than the specified value, test the circuit for a short to ground.

6. Test for less than 1 ohm between the following signal circuit terminals.

* Right front end sensor terminal 1 and SDM terminal 37.

* Left front end sensor terminal 1 and SDM terminal 36.

* Right front side impact sensor terminal B and the SDM terminal 43.

* Left front side impact sensor terminal B and the SDM terminal 42.

* Right rear side impact sensor terminal B and the SDM terminal 45.

* Left rear side impact sensor terminal B and the SDM terminal 44.

瀚慖f greater than the specified range, test the circuit for an open/high resistance.

7. Test for less then 1 ohm between the following front end sensor low reference circuit terminals.

* Right front end sensor terminal 2 and SDM terminal 39.

* Left front end sensor terminal 2 and SDM terminal 38.

* Right front side impact sensor terminal A and the SDM terminal 41.

* Left front side impact sensor terminal A and the SDM terminal 40.

* Right rear side impact sensor terminal A and the SDM terminal 47.

No comments:

Post a Comment