2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 568

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 568

B2345 13

Any of the temperature sensor inputs remains below 1.5 V for a seat back or 0.95 V for a seat cushion more than 1 second.

B2345 42

This DTC will set if the module calibration is not programmed.

B2345 4B

This DTC will set if the module calibration is out of range.

Action Taken When the DTC Sets

The heated seat functions for both seats will be disabled.

Conditions for Clearing the DTC

* The current DTC clears when the malfunction is no longer present and the power mode changes to OFF then back to ACC or RUN.

* The history DTC will clear after 50 consecutive fault-free ignition cycles have occurred.

Reference Information

Schematic Reference

Heated/Cooled Seat Schematics ()

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Heated Seats Description and Operation (KA1) ()Heated Seats Description and Operation (KA6) ()

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Verification

Verify the type of vehicle and the heated seat system for which the DTC set.

If the DTC set in a vehicle equipped with memory, refer to Circuit/System Testing below.

If the DTC set in a hybrid vehicle without memory, refer to DTC B2345 (HP2 w/o memory).

If the DTC set in a non-hybrid vehicle without memory, refer to DTC B2345 (Dealer installed).

If the DTC set in the rear heated seat module, refer to DTC B2345 (Rear seat).

Circuit/System Testing

B2345 00

1. Ignition OFF, disconnect the X1, X4 harness connectors at the MSM.

2. Test for infinite resistance between the control circuit terminal 14 X1 and ground.

瀚慖f not the specified value, test the control circuits listed below for a short to ground:

* Driver seat cushion and seat back terminal 14 X1

* Driver seat cushion element terminal 11 X1

* Driver seat back element terminal 1 X1

3. Test for infinite resistance between the control circuit terminal 6 X1 and ground.