Thursday, November 7, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1298

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1298

- Drive Motor 2 Phase U Current Sensor Circuit Low Voltage

DTC P0BF4

- Drive Motor 2 Phase U Current Sensor Circuit High Voltage

DTC P0BF6

- Drive Motor 2 Phase V Current Sensor Performance

DTC P0BF7

- Drive Motor 2 Phase V Current Sensor Circuit Low Voltage

DTC P0BF8

- Drive Motor 2 Phase V Current Sensor Circuit High Voltage

DTC P0BFA

- Drive Motor 2 Phase W Current Sensor Performance

DTC P0BFB

- Drive Motor 2 Phase W Current Sensor Circuit Low Voltage

DTC P0BFC

- Drive Motor 2 Phase W Current Sensor Circuit High Voltage

Circuit/System Description

This is an internal fault detection of the drive motor generator power inverter module (PIM) assembly. This fault is handled inside the PIM and no

external circuits are involved.

Conditions for Running the DTC

The control module runs the program to detect an internal fault when the Hybrid wake-up circuit is active.

Conditions for Setting the DTC

The control module has detected an internal malfunction.

Action Taken When the DTC Sets

* DTCs P0BE6, P0BE7, P0BE8, P0BEA, P0BEB, P0BEC, P0BEE, P0BEF, P0BF0, P0BF2, P0BF3, P0BF4, P0BF6, P0BF7, P0BF8, P0BFA,

P0BFB and P0BFC are Type B DTCs.

* The PIM commands the battery energy control module (BECM) to open the high voltage contactor relays.

Conditions for Clearing the DTC

DTCs P0BE6, P0BE7, P0BE8, P0BEA, P0BEB, P0BEC, P0BEE, P0BEF, P0BF0, P0BF2, P0BF3, P0BF4, P0BF6, P0BF7, P0BF8, P0BFA,

P0BFB and P0BFC are Type B DTCs.

Reference Information

DTC Type Reference

Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code

(DTC) Type Definitions)

Circuit/System Verification

1. Clear the DTC information.

2. Ignition OFF for 1 minute.

3. Ignition ON.

4. Retest for DTCs P0BE6, P0BE7, P0BE8, P0BEA, P0BEB, P0BEC, P0BEE, P0BEF, P0BF0, P0BF2, P0BF3, P0BF4, P0BF6, P0BF7,

P0BF8, P0BFA, P0BFB or P0BFC.

Circuit/System Testing

Program the PIM with the latest software version and recheck for DTCs.

If the DTC resets after programming or if the PIM already contains the latest software version, replace the PIM.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

No comments:

Post a Comment