2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1044

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1044

* Battery Inspection/Test (See: Starting and Charging/Testing and Inspection/Component Tests and General Diagnostics/Battery

Inspection/Test)

* Battery Common Causes of Malfunction (See: Starting and Charging/Testing and Inspection/Component Tests and General

Diagnostics/Battery Common Causes of Malfunction)

* Battery Electrical Drain/Parasitic Load Test (See: Starting and Charging/Testing and Inspection/Component Tests and General

Diagnostics/Battery Electrical Drain/Parasitic Load Test)

* Charging System Test (See: Starting and Charging/Testing and Inspection/Component Tests and General Diagnostics/Charging System Test

)

C0899

DTC C0899

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of this diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC C0899 00

- Device Voltage Low - EBCM (w/o JL4)

DTC C0899 03

- Device Voltage Low - EBCM (JL4)

Diagnostic Fault Information

Typical Scan Tool Data

Circuit/System Description

The electronic brake control module (EBCM) monitors the battery positive (B+) voltage level available for system operation. A low voltage

condition prevents the system from operating properly.

Conditions for Running the DTC

The ignition is ON.

Conditions for Setting the DTC

The ignition voltage available to the EBCM is less than 9 volts for 100 msec.

Action Taken When the DTC Sets

* The traction control system (TCS) and vehicle stability enhancement system (VSES) are disabled for the duration of the ignition cycle

* The vehicle dynamics caution (VDC) indicator turns ON.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The EBCM automatically clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.