2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 479
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC B1449 03
- Remote Device Voltage Below Threshold
DTC B1449 07
- Remote Device Voltage Above Threshold
Diagnostic Fault Information
Circuit/System Description
The infrared module is supplied with 10.5 volts from the rear audio/HVAC module when the rear audio system is active. The infrared module is
permanently grounded at G300.
Conditions for Running the DTC
* Ignition ON.
* Battery voltage must be between 9-16 volts.
Conditions for Setting the DTC
The DTC will set when the rear audio/HVAC module detects a short to voltage, short to ground, or an open/high resistance in the infrared module
voltage signal circuit.
Action Taken When the DTC Sets
The rear audio/HVAC module sets the DTC and the infrared module will be disabled.
Conditions for Clearing the DTC
* The condition responsible for setting the DTC no longer exists.
* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.
Reference Information
Schematic Reference
Radio/Navigation System Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Radio/Navigation System
Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Video Entertainment System Description and Operation (Non-Headrest DVD Systems) (See: Accessories and Optional Equipment/Description
and Operation/Video Entertainment System Description and Operation (Non-Headrest DVD Systems))Video Entertainment System Description
and Operation (Dual Headrest DVD Systems) (See: Accessories and Optional Equipment/Description and Operation/Video Entertainment System
Description and Operation (Dual Headrest DVD Systems))
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
No comments:
Post a Comment