2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1213
P0A8E
DTC P0A8E
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptor
DTC P0A8E
- 14 Volt Power Module System Voltage High
Circuit/System Description
The Accessory Power Module (APM) continuously monitors its 14 volt circuit during charge or Jump Assist. This DTC sets when the 14 volt
circuit in the APM rises above a set level. APM functions will run only when an APM enable message from the Hybrid Powertrain Control Module
(HPCM) is active on the high speed hybrid GMLAN communication circuit.
Conditions for Running the DTC
APM is charging or in Jump Assist.
Conditions for Setting the DTC
* 14 volt circuit is above 16.5 volts while charging.
* 14 volt circuit is above 16.0 volts in Jump-Assist.
Action Taken When the DTC Sets
* DTC P0A8E is a Type C DTC.
* The APM will shutdown charging or Jump Assist.
Conditions for Clearing the DTC
* 14 volt circuit is below 16.3 volts while charging.
* 14 volt circuit is below 15.8 volts in Jump-Assist.
Diagnostic Aids
* A possible cause of this DTC could be overcharging with a battery charger or jump starting.
* A high voltage value in multiple modules indicates a concern in the charging system.
Reference Information
Schematic Reference
Hybrid Controls Schematics ()
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Drive Motor Generator Control Module Description and Operation ()
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
DTC Type Reference
Powertrain Diagnostic Trouble Code (DTC) Type Definitions (See: Diagnostic Trouble Code Descriptions/Powertrain Diagnostic Trouble Code
No comments:
Post a Comment