Friday, November 15, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 660

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 660

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the harness connector at the headlamp switch.

2. Verify that a test lamp illuminates between B+ and the ground circuit terminal 8.

瀚慖f the test lamp does not illuminate, test the ground circuit for an open/high resistance.

3. Ignition ON, verify the scan tool Rear Fog Lamp Switch parameter is INACTIVE.

瀚慖f not the specified value, test the signal circuit terminal 6 for a short to ground. If the circuit tests normal, replace the XBCM.

4. Install a 3 A fused jumper wire between the signal circuit terminal 6 and ground. Verify the scan tool Rear Fog Lamp Switch parameter is

ACTIVE.

瀚慖f not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the

XBCM.

5. If all circuits test normal, test or replace the headlamp switch.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Headlamp Switch Replacement (Cadillac) (See: Lighting and Horns/Headlamp/Headlamp Switch/Service and Repair/Headlamp Switch

Replacement (Cadillac)) Headlamp Switch Replacement (Except Cadillac) (See: Lighting and Horns/Headlamp/Headlamp Switch/Service

and Repair/Headlamp Switch Replacement (Except Cadillac))

* Control Module References (See: Testing and Inspection/Programming and Relearning) for XBCM replacement, setup, and programming

B2545

DTC B2545

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptor

DTC B2545 00

- Backup Lamps Circuit

Diagnostic Fault Information

Circuit/System Description

When the transmission is placed in the REVERSE position, the transmission control module (TCM) sends a serial data message to the body control

module (BCM). The message indicates that the gear selector is in the REVERSE position. The BCM applies voltage to the backup lamp relay

No comments:

Post a Comment