Monday, November 18, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 881

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 881

The EBCM detects that the sensor supply voltage is less than 11.75 volts for 30 milliseconds.

C0292 07

The EBCM detects that the sensor supply voltage is greater than 12.25 volts for 30 milliseconds.

Action Taken When the DTC Sets

* The EBCM disables the traction control system (TCS)/vehicle stability enhancement system (VSES) for the duration of the ignition cycle.

* The driver information center (DIC) displays the Service StabiliTrak message, AWD Off, and Service Brake Assist messages.

Conditions for Clearing the DTC

The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Antilock Brake System Schematics (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

ABS Description and Operation (See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Description and Operation/ABS

Description and Operation)

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information

Circuit/System Testing

1. Ignition OFF, disconnect the yaw/lateral accelerometer sensor connector.

2. Ignition OFF for 5 minutes, test for less than 10 ohms between the low reference circuit terminal 6 and ground.

瀚慖f greater than the specified range, test the low reference circuit for an open/high resistance. If the circuits test normal, replace the EBCM.

3. Ignition ON, test for 11.75-12.25 volts between the 12-volt reference circuit terminal 1 and ground.

瀚慖f less than the specified range, test the 12-volt reference circuit for a short to ground or an open/high resistance. If the circuit tests

normal, replace the EBCM.

瀚慖f greater than the specified range, test the 12-volt reference circuit for a short to voltage. If the circuit tests normal, replace the EBCM.

4. If all circuits test normal, replace the yaw/lateral accelerometer sensor.

Repair Instructions

Perform the Diagnostic Repair Verification (See: Verification Tests) after completing the diagnostic procedure.

* Vehicle Yaw Sensor with Vehicle Lateral Accelerometer Replacement (See: Brakes and Traction Control/Antilock Brakes / Traction

Control Systems/Yaw Rate Sensor/Service and Repair/Less than 3900 kg (8600 lb) GVW)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for EBCM replacement, setup, and programming

No comments:

Post a Comment