Monday, November 4, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1048

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1048

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions)provides an overview of each diagnostic category.

DTC Descriptor

DTC C1100 00

- Base Brake System Pressure Circuit

Diagnostic Fault Information

Circuit/System Description

The electronic brake control module (EBCM) provides a 5 V reference circuit to the brake booster vacuum sensor and the steering angle sensor.

The brake booster vacuum sensor converts the change in vacuum levels in the brake booster into a signal voltage ranging from 0.13 - 3.30 V and is

monitored by EBCM.

Conditions for Running the DTC

Ignition ON.

Conditions for Setting the DTC

The brake booster sensor signal voltage is not within 0.13 - 3.30 V for more than 1 second.

Conditions for Clearing the DTC

* The condition for the DTC is no longer present.

* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.

Reference Information

Schematic Reference

Hydraulic Brake Schematics (See: Brakes and Traction Control/Hydraulic System/Diagrams/Electrical Diagrams)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Brake Assist System Description and Operation (Vacuum Assist) (See: Brakes and Traction Control/Hydraulic System/Description and

Operation/Brake Assist System Description and Operation (Vacuum Assist))Brake Assist System Description and Operation (Hydraulic Assist) (

See: Brakes and Traction Control/Hydraulic System/Description and Operation/Brake Assist System Description and Operation (Hydraulic Assist))

Electrical Information Reference

* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit

Testing/Circuit Testing)

* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic

Procedures/Connector Repairs/Connector Repairs)

* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General

Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)

* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring

Repairs/Wiring Repairs)

Scan Tool Reference

Control Module References (See: Testing and Inspection/Programming and Relearning)for scan tool information

Circuit/System Testing

Note: If only DTC C1100 is set refer to Only DTC C1100 Set, if both DTC C0710 and C1100 are set, refer to Both DTC C0710 and C1100 Set.

No comments:

Post a Comment