2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 466

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 466

Positioning System/Pedal Positioning Sensor/Service and Repair)

* Tilt Motor Replacement (See: Steering and Suspension/Steering/Steering Column/Tilt Wheel Motor/Service and Repair)

* Control Module References (See: Testing and Inspection/Programming and Relearning) for MSM replacement, setup, and programming

B1405

DTC B1405

Diagnostic Instructions

* Perform the Diagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System

Check - Vehicle) prior to using this diagnostic procedure.

* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an

overview of the diagnostic approach.

* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure

Instructions) provides an overview of each diagnostic category.

DTC Descriptors

DTC B1405 02

- Control Module Voltage Reference Output 2 Circuit Short to Ground

DTC B1405 03

- Control Module Voltage Reference Output 2 Circuit Low Voltage

DTC B1405 07

- Control Module Voltage Reference Output 2 Circuit High Voltage

Diagnostic Fault Information

Circuit/System Description

The object sensors are 3-wire sensors that are used to determine the distance between the vehicle and an object of interest. The parking assist

control module supplies 8 V to the object sensors via the 8 V reference circuit and provides ground via the low reference circuit. The parking assist

control module triggers the sensors in a sequential loop. After each sensor transmits, the parking assist control module uses the sensor echo

received through the signal circuit to calculate the distance and position of an object.

Conditions for Running the DTC

* Ignition ON

* Transmission in REVERSE

Conditions for Setting the DTC

B1405 02

The parking assist control module has detected the 8 V reference circuit is shorted to ground.

B1405 03

The parking assist control module has detected the 8 V reference circuit is less than 6.3 V.