2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 1042
* Review Strategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
* Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure
Instructions) provides an overview of each diagnostic category.
DTC Descriptors
DTC C0896 03
- Device Voltage Range Below Threshold
DTC C0896 07
- Device Voltage Range Above Threshold
Circuit/System Description
The transfer case shift control module (TCCM) monitors the battery voltage feed to the TCCM. This DTC detects if the battery voltage is out of
range. This could indicate a vehicle wide issue in which all electrical components would be affected, or it could be TCCM specific due to poor
power or ground connections.
Conditions for Running the DTC
* Ignition ON.
* System voltage 10.5-18.5 V.
Conditions for Setting the DTC
System voltage above 18.5 V or below 10.5 and a mode shift is requested.
Action Taken When the DTC Sets
* Shifting disabled until battery voltage is within specification.
* Mode indicator will illuminate current mode.
Conditions for Clearing the DTC
* The TCCM clears the DTC once the conditions for setting the DTC are no longer present.
* A history DTC clears after 40 consecutive warm up cycles without a fault present.
* History DTCs can be cleared using a scan tool.
Diagnostic Aids
* Any mode shift requested when the battery voltage is below 12 V may set this DTC.
* Improperly connecting the cables during a jump start can cause C0896 07 to set.
* The Transfer Case High/Low Clutch Reset (See: Transmission and Drivetrain/Transfer Case/Testing and Inspection/Symptom Related
Diagnostic Procedures/MP 3023/3024-NQH - Transfer Case/Transfer Case High/Low Clutch Reset) procedure may need to be performed
after repair.
* EL-49742 - harness is a good source for B+ and ground.
Reference Information
Schematic Reference
Transfer Case Control Schematics (See: Transmission and Drivetrain/Transfer Case/Diagrams/Electrical Diagrams/MP 3023/3024-NQH -
Transfer Case)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Electrical Information Reference
* Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Circuit
Testing/Circuit Testing)
* Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic
Procedures/Connector Repairs/Connector Repairs)
* Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics/General
Electrical Diagnostic Procedures/Circuit Testing/Testing for Intermittent Conditions and Poor Connections)
* Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics/General Electrical Diagnostic Procedures/Wiring
Repairs/Wiring Repairs)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information.
No comments:
Post a Comment