Friday, November 15, 2019

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 664

2010 Cadillac Truck Escalade EXT AWD V8-6.2L Page 664

DTC Descriptor

DTC 2575 00

- Headlamp Control Circuit

Diagnostic Fault Information

Circuit/System Description

When the Headlamp and Panel Dimmer Switch is placed in the headlamp ON position, ground is applied to the body control module (BCM)

through the headlamp low beam signal circuit. The BCM then applies ground to the HDLP LO/HID Relay control circuit which energizes the low

beam relay. With the low beam relay energized, the switch contacts close allowing B+ to flow through the LOW HDLP fuses to the low beam

headlamps.

Conditions for Running the DTC

* Battery voltage must be between 9-16 V.

* Headlamps must be ON.

Conditions for Setting the DTC

The BCM detects a short to voltage in the headlamp low beam relay control circuit.

Actions Taken When the DTC Sets

The low beam headlamps will not operate.

Conditions for Clearing the DTC

* The condition responsible for setting the DTC no longer exists.

* A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred.

Reference Information

Schematic Reference

Headlights/Daytime Running Lights (DRL) Schematics (See: Diagrams/Electrical Diagrams/Lighting and Horns/System

Diagram/Headlights/Daytime Running Lights (DRL) Schematics)

Connector End View Reference

Component Connector End Views (See: Diagrams/Connector Views)

Description and Operation

Exterior Lighting Systems Description and Operation (See: Lighting and Horns/Description and Operation/Exterior Lighting Systems Description

No comments:

Post a Comment