Wednesday, September 18, 2019

Vin ListJaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S307-02 Date: 990701

Vin ListJaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S307-02 Date: 990701



Ignition Key - Unable to Remove



BULLETIN:



S307-02



GROUP:



S-TYPE



DATE:



7/99



SUBJECT:



Stuck Ignition Key - Modify J-Gate Interlock Lever - Service Action S114



MODEL:



2000 MY-ON



S-TYPE



VIN



L00600-LO11869



Issue:



Some 2000 MY S-TYPE vehicles within the above VIN range may, under high temperature conditions, experience a malfunction of the J-Gate



interlock mechanism which results in the inability to remove the ignition key when the gear selector lever is placed in "Park".



This bulletin provides a procedure to install an e-clip on the pivot bolt to increase the clearance of the pivot of the interlock lever.



Action:



Check if the service action has already been performed on the vehicle by performing a DCS claim search. If the service action has not yet been



performed, modify the interlock lever of all 2000 MY S-TYPE vehicles within the above VIN range before sale or at the first service opportunity.



Install the e-clip using the procedure outlined in this bulletin.



MODIFYING PIVOT BOLT OF INTERLOCK LEVER



2000 Jaguar S-Type (X200) V6-3.0L Page 166



1. Fully apply the parking brake. Release the snap fastener of the boot on the parking brake lever.



2. Lift up the lid of the center console.



3. Move the gear shift selector lever to "Neutral".



4. Raise the upper console. (Clips may become detached - there is a total of 7 clips).



5. Reach under the console to detach the electrical connectors for the Traction Control Switch, Sports/Normal mode switch, cigar lighter and



phone connections, where applicable.



6. On the right side of the J-gate assembly, remove the pivot bolt that retains the interlock lever (Illustration 1).



7. Check for any excess thread locking compound on the interlock lever. Wipe off any excess.



8. Install a 3/16 inch e-clip on to the bolt (Illustration 1), ensuring that the e-clip does not extend beyond the shank of the bolt. Make sure that the



bolt turns freely in the lever. If necessary, use a reamer to bevel the opening of the lever.



9. Reinstall the bolt. Do not use thread locking compound.



10. Ensure that the interlock lever moves freely and that the key can be easily removed when the range selector lever is in "Park".



11. Reassemble the console components in the vehicle.



NOTE:



Always perform a DCS claim search first to determine whether this service action has been performed on this vehicle. The warranty selection



under the vehicle inquiry will give a listing of all claims against the vehicle. If 5114 appears in the fault code field, do not perform this service



action.



2000 Jaguar S-Type (X200) V6-3.0L Page 167



Parts And Warranty Information



Parts and Warranty Information



CLAIM SUBMISSION PROCEDURE:



Warranty summary codes have been assigned to this service action in order to simplify claim submission. The dealership will be reimbursed the parts



and labor time allowance as indicated.



DCS DEALERS



Submit claims using the appropriate summary code for the vehicle model and work performed. Follow standard campaign submission procedures.



NON-DCS DEALERS



Submit claims on the Recall Campaign Summary form W-25. Enter the appropriate summary code for the vehicle model and work performed in the



Repair Code column. Do not use the W-1 warranty claim form.

No comments:

Post a Comment