Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S417-01 Date: 000401
Lighting - Daytime Running Lamps Enable/Disable
S417-01
S-TYPE
DATE 04/00
MODEL
2000 MY-ON
S-TYPE
VIN
L00001-ON
2000 Jaguar S-Type (X200) V6-3.0L Page 196
Daytime Running Lamps - Enable/Disable
Issue:
The daytime running lamps feature of S-TYPE vehicles may be enabled/disabled as a customer requested option, except in markets where daytime
running lamps are either mandatory or prohibited. Daytime running lamps are permissible in the USA.
Action:
In markets where daytime running lamps are mandatory, ensure that this feature is ON. Should it be necessary to change the existing setting, the
following PDU procedure should be followed:
1. Locate PDU disk JTP 627/5 or later and load into PDU.
2. Highlight DIAGNOSTICS.
3. Enter VIN.
4. Enter VEHICLE FEATURES.
5. In the Main Menu, select VEHICLE SET-UP
6. Select VEHICLE CM SET-UP/CONFIGURATION.
7. Initiate MPA.
8. Connect PDU and MPA to vehicle.
9. Select DEALER OPTIONS.
Caution:
North American Specification vehicles are not equipped with steering column locks. Ensure that NO is selected.
10. Select DAYLIGHT RUNNING LAMPS MODE.
11. Then highlight the required mode to enable the feature or remove the highlight to disable the feature:
REST OF WORLD LAMPS ENABLE CANADIAN DAYLIGHT RUNNING LAMPS ENABLE
12. When one of the above modes has been highlighted, press the check mark, then the PDU will confirm that it has been successfully
programmed.
13. Check the function of the daytime running lights, by starting the engine and placing the selector lever in Reverse or Drive ranges. Daytime
running lights will not function in Park or Neutral.
Warranty Information:
This Bulletin is issued for information only.
No comments:
Post a Comment