Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S910-01 Date: 990701

Jaguar S-Type (X200) V6-3.0L Technical Service Bulletin # S910-01 Date: 990701

Vehicle Jack - Incorrect Retaining Bolt

S910-01

DATE 7/99

MODEL

2000 MY-ON S-TYPE

VIN

L02123-06274

Incorrect Retaining Bolt -

Vehicle Jack - Service Action S115

Issue:

S-TYPE vehicles within the above VIN range may have the wrong retaining bolt for correct retention of the vehicle jack. The bolt may be too short,

and may not allow full engagement to secure the jack and associated foam pack containing the towing eye to the floor pan. This condition may cause

a rattle from the luggage compartment.

Action:

At the first service opportunity, install a longer retaining bolt and correctly arrange and, if necessary, relocate the toam pack that houses the towing

eye as described below.

PROCEDURE

2000 Jaguar S-Type (X200) V6-3.0L Page 168

1. Release and open the lid of the luggage compartment.

2. Remove the spare tire cover and, where applicable, the foam surround of the spare wheel.

3. Remove the support pad and the spare tire retaining wing nut and washer. Lift out the spare tire.

4. If the retaining bolt for the jack has a downward-pointing cone on its stem, remove and discard the bolt. Remove the jack along with the

molded foam block that stores the towing eye.

5. If necessary, remove and discard any tie strap connecting the jack retaining bolt and the molded foam block.

6. If necessary, rearrange the towing eye correctly in the foam block and correctly position the block in the arms of the jack, as shown in

Illustration 1, between the actuating thread and upper arms of the jack.

7. Ensure that the operating handle is folded into the position shown in Illustration 1.

8. Replace the jack assembly. Discard any retaining bolt that has a cone, pointing downwards, on its stem. Install and tighten the replacement

securing bolt (arrow, Illustration 1), so the washer locates against the bend in the jack operating handle.

9. Check that the wheel nut wrench is correctly stored as illustrated.

10. Reinstall the spare tire, washer, retaining nut and support pad.

11. If applicable, reinstall the foam surround followed by the cover.

12. Close the lid of the luggage compartment.

Parts Information:

DESCRIPTION PART NUMBER QTY

Retaining bolt, jack XR86103 1

Warranty Information:

Service Action S115

VEHICLE SUMMARY DESCRIPTION TIME

CODE ALLOWANCE

S-TYPE AT Replace jack retaining bolt 0.15 hrs.

2000 MY -without drive-in/out time

VIN L021 23-L06274 (performed with another repair.)

Model codes 6100,

6300,6310

S-TYPE AV Replace jack retaining bolt

2000 MY -with drive-in/out time 0.15 hrs.

2000 Jaguar S-Type (X200) V6-3.0L Page 169

VIN L021 23-L06274 (only repair performed)

Model codes 6100,

6300,6310

NOTE:

Always perform a DCS claim search first to determine whether this service action has been performed on this vehicle. The warranty selection

under the vehicle inquiry will give a listing of all claims against the vehicle. If S115 appears in the fault code field, do not perform this service

action.

CLAIM SUBMISSION PROCEDURE:

Warranty summary codes have been assigned to this service action in order to simplify claim submission. The dealership will be reimbursed the parts

and labor time allowance as indicated.

DCS DEALERS

Submit claims using the appropriate summary code for the vehicle model and work performed. Follow standard campaign submission procedures.

NON-DCS DEALERS

Submit claims on the Recall Campaign Summary form W-25. Enter the appropriate summary code for the vehicle model and work performed in the

Repair Code column. Do not use the W-1 warranty claim form.