Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLS501011 Date: 060222

Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L Technical Service Bulletin # TECLS501011 Date: 060222

Instruments/Body - Door Mirror Rattles

No.: LS-501-011

Issue: 1

Date: February 22, 2006

SECTION: 501-09

Exterior Rear View Mirror Glass

AFFECTED VEHICLE RANGE:

Land Rover Range Rover Sport (LS) VIN: 6A900129 onwards

CONDITION SUMMARY:

DOOR MIRROR GLASS RATTLE

A customer may report a concern of a rattle from the door mirror.

Cause:

Mirror manufacturer build process resulted in an incorrect mirror motor alignment, prior to the installation of the motor retaining screw. When the

mirror glass is installed to the mirror assembly, the motor is clicked into its correct location, relieving the applied torque of the motor retaining

screws.

Action:

Should a customer express concern regarding the above, refer to the Repair Procedure detailed in this bulletin.

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.

Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

REPAIR PROCEDURE

TIGHTEN EXTERIOR MIRROR MOTOR SCREW

1. Manually move the affected RH and/or LH exterior rear view mirror glass to its fully inboard position.

2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 147

2. If unsecured movement of the glass is found in the direction shown proceed to step 3. (Figure 1)

3. Remove the mirror glass as follows:

^ Manually move the glass to its fully up tilted position.

^ Carefully apply pressure to the bottom of the glass in the direction of the arrow. (Figure 2)

^ Disengage the lower edge of the glass back-plate away from the motor.

2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 148

^ Lift the glass upwards to disengage the two clips "C" from the motor. (Figure 3)

NOTE:

The two locating ribs, identified as "C" may fracture during mirror detachment. This is normal and does not affect the reinstallation,

retention or function of the mirror glass and should not be replaced. (Figure 3)

4. Ensure the motor is fully secured and located into correct position.

5. Centralize the motor and tighten the Torx screw to a maximum torque of 1.0 Nm (8.5 in-lb). (Figure 4)

2010 Land Rover Range Rover Sport (LS) V8-5.0L Page 149

6. Install the mirror glass by aligning the locations "A" on the glass assembly with the corresponding locations on the motor. (Figure 5)

7. Press the lower edge of the glass assembly firmly into the mirror assembly until an audible click is heard when the retention rib engages with

the motor.

8. Confirm that the mirror glass is securely retained.