Sunday, June 16, 2019

Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Technical Service Bulletin # TECLTB00422 Date: 111209

Disclaimer2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Technical Service Bulletin # TECLTB00422 Date: 111209



Interior - Load Space Front Trim Panel Loose or Poor Fit



LTB00422NAS1



2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Page 55



09 DEC 2011



SECTION: 501



Load Space Front Trim Panel Retaining Strap Replacement



AFFECTED VEHICLE RANGE:



Range Rover Sport (LS) VIN: 6A900290 - Onwards



Model Year: 2006 - Onwards



CONDITION SUMMARY:



Situation:



The load space front trim panel may become loose or fits poorly. This may be caused by the bungee straps which retain the trim becoming



disconnected or broken.



Action:



In the event of a customer concern of the above, refer to the Repair Procedure outlined below to replace the load space front retaining strap.



PARTS



TOOLS:



Refer to Workshop Manual for any required special tools



WARRANTY:



NOTE:



Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always



refer to DDW to obtain the latest repair time.



DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.



REPAIR PROCEDURE



REPLACE LOAD SPACE FRONT TRIM PANEL BUNGEE CORDS



2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Page 56



1. Fold the rear seat down so that the affected load space front trim panel rests in the horizontal position. (Figure 1)



NOTE:



There are two (2) bungee cords on each of the trim panels.



2. Lift affected load space front trim panel to gain access to bungee cord. (Figure 2)



3. Locate bungee cord upper fixing. (Figure 3)



2010 Land Rover Range Rover Sport (LS) V8-5.0L SC Page 57



4. Slide bungee cord fixing along channel it is located in towards the closest edge and remove from channel. (Figure 4)



5. Pull cord into the slot on one side of the plastic tube. The cord is now in line with the plastic tube. (Figure 5)



6. Push the plastic tube back through the lower hole; remove and discard complete bungee assembly. (Figure 6)



7. Repeat steps 3 - 6 to the other bungee cord of the affected load space front trim panel.



8. Reverse steps 6 - 3, installing two (2) new bungee cords.



9. Lower the load space front trim panel.

No comments:

Post a Comment