Disclaimer2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB002562 Date: 100205

Disclaimer2010 Land Rover Range Rover (LM) V8-5.0L SC Technical Service Bulletin # TECLTB002562 Date: 100205

Body - Erratic Rear Door Window Glass Operation

No: LTB00256

Issue: 2

Date: 05 FEB 2010

ISSUE '2' CHANGES ARE HIGHLIGHTED WITH ASTERISKS

SECTION: 501

Rear Door Window Glass Closing Incorrectly

2010 Land Rover Range Rover (LM) V8-5.0L SC Page 172

AFFECTED VEHICLE RANGE:

CONDITION SUMMARY:

Situation:

The left and right rear door window glass may close and then immediately reopen or the one-touch up function may be inoperative. This may be

caused by the Hall sensor incrementing when the vehicle 'wakes up', causing the door module to record the incorrect glass position.

Action:

In the event of a customer concern of the above, refer to the Repair Procedure outlined below to configure the Drive's and Passengers Door Modules.

PARTS:

No parts necessary

TOOLS:

*IDS with IDS-DVD120_V6.02 or later and Calibration 25 or later*

Land Rover-approved Midtronics Vehicle Power Supply

WARRANTY:

NOTE:

Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only.

Always refer to DDW to obtain the latest repair time.

DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.

Normal warranty policy and procedures apply.

REPAIR PROCEDURE

CAUTION:

Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the

vehicle.

CAUTION:

A Land Rover-approved Midtronics Vehicle Power Supply must be connected to the vehicle battery during IDS diagnosis / module

programming.

1. Connect the Land Rover-approved Midtronics Vehicle Power Supply to the vehicle battery.

NOTE:

IDS must be loaded with IDS-DVD120_V6.02 or later and Calibration File 25 or later.

2. Connect the Integrated Diagnostic System (IDS) to the vehicle and begin a new Symptom Driven Diagnostics (SDD) session.

3. Follow the on-screen prompts, allowing SDD to read the VIN and identify the vehicle.

4. From the Session Type selection screen, choose 'Diagnosis'.

5. Select the Selected Symptoms tab, and then select:

^ Body > Glass panels > Glass movement

6. Select 'Continue'.

7. Select the Recommendations tab.

8. From the Recommendations screen, select Run to configure the 'Drivers door module'.

^ Follow all on-screen instructions to complete this task.

2010 Land Rover Range Rover (LM) V8-5.0L SC Page 173

9. From the Recommendations screen, select Run to configure the 'Passengers door module'.

^ Follow all on-screen instructions to complete this task.

10. Exit the current session.

11. Disconnect the IDS and the Midtronics Vehicle Power Supply from the vehicle.

12. Verify one touch up and anti-trap functions of all windows.